Higher 16 bit address of the peer device.
| PEER_ADDR_H | Higher 16 bit of 48-bit address of the peer device. The peer address registers are used for multiple purposes. The register is written by firmware to provide the peer address to be used for a hardware procedure. When firmware reads the register, it reads back peer address values updated by hardware. While doing directed Advertising, the firmware writes the peer address of the device specified by the Di-rect_Address parameter of the LE_Set_Advertising_Parameters command. In non MMMS mode, While device is configured as an initiator without white list filtering, the peer address specified in the peer_address field of the create connection command is programmed into this register, which is used by hard-ware procedures. In non MMMS mode, While device is configured as an initiator and white list is enabled, firmware can read this register to get the address of the peer device from which connectable ADV packet was received and to which the connection is created. When a connection is created as a slave, the firmware can read this register to get the address of the peer de-vice to which connection is created. |